Reolink doorbell camera - Onvif commands

[TimG]

There might be something in that. Homeseer gets all Onvif commands, but BI5 seems to miss a few. My doorbell works well though. And Homeseer announces the doorbell press on all Alexa devices, also Pushover alerts it on my phone.

[Grisu]

I have tested it with the Doorbell POE.
I can see in the log file that it is triggered,
but there is no alert.

I have also added a mail dispatch, but that doesn't work either. However, if I execute the trigger manually, it works.

What could be the cause?
Does AI have to be installed for this function?

1.png (17.98 KiB) Viewed 7618 times

2.png (24.92 KiB) Viewed 7618 times

[TimG]

I can't see anything wrong there. Do you see GetEvents= OK ?
What I DO know is that Homeseer catches more of the Onvif commands than BI5 does. I deleted a lot of Actions in case BI5 was overloaded but that didn't help. More experimentation required.

[Grisu]

Thank you for your answer.
Yes GetEvents= OK.
As written, I also get the entry in the log:
ONVIF Event: Tuerklingel

The alarm is still not triggered.

Otherwise I do not use Homeseer but cam2mqtt which works perfectly.

[dbowles1975]

It does work. The camera sends out an ONVIF command called "Visitor" when the doorbell is pressed (If you have enabled ONVIF in the actual camera). The issue is capturing that with BI5 and doing something with it.

I'm having an issue where BI is sending the alert twice. I'm not sure if this is because of the way I have the doorbell configured, or if I'm doing something wrong in BI. Did you have this issue or do you know how I might go about getting the alert to only send once? Thanks.