Correct Local IP in Blue Iris Web Server

[rgj34169]

My Blue Iris server has Issues it turns out that the Web Server Local IP now is a MAC Address and Port.
I have tried changing the Line but is frozen no change or delete possible.
When I tried going to the Remote Access Wizard everything that used to have my local Ip is gone and where there is a reference to the Local Ip the MAC Address is listed.
How do I correct this???
If you say just create a new one. Do I use the port I had before or do I have to use a new Port???
Please Help

Thanks

Joe

[BruceH]

I believe that is your local IP6 address not a mac address, do you have IP4 enabled or are you just using IP6 on your local network!

I hope you do not have that port open as you just published your WAN internet address for the whole world to see and try and hack into!

[TimG]

I've deleted the image to protect the OP. I agree that was an IP6 LAN IP address not a MAC address.

[rgj34169]

Thanks You.

[BruceH]

Are you still having problems, that you need help with?

[rgj34169]

Bruce

Yes, it started Friday Night. I have 12 cameras on my desktop. Since Saturday, when I double click on a camera screen. I get a black Screen. I have tried editing the Main Screen, but I can't move anything. The cameras are not in the order of the camera listing on the Blue Iris Status Cameras Tab.

I have a post on How to completely uninstall Blue Iris and then do a New Complete install.
I have all the data required to do the install.

I wish I could figure out what happed to my Desktop.

I'm attaching a screen shot.

Thanks

Joe

[BruceH]

So just to clarify that the cameras are all working in the screen that you posted, but show completely blank/black when opened to a single camera view!

[rgj34169]

Yes when camera is open the whole screen is black till I click on the screen or press esc.

Thanks for the reply.

Joe

[BruceH]

Joe when you double click on a camera is there any border for the screen, or is the entire screen blank? if you left click on the screen do you get a menu that pops up?

[rgj34169]

Bruce

First thanks for the reply.

When I double click on a camera I get a complete blank screen. No border.
If I left Click on the Blank screen I get nothing if I Right click on the blank screen I get the normal full camera menu.
I want to point out on the Image Attachment I sent you at the bottom right of the screen that is not a camera and when I right clip.
I get the same popup as I would by right clicking the Main Screen.

Thanks

Joe