Blue Iris

I think I may be starting to understand this.

Zone A - Even though your not referencing this in your Zone Crossings, by defining this Zone it's still going to process the motion sensor outside of Zone B, but not trigger. You many want to try to define Zone A just outside Zone B's boarder. Bring Zone A in on the sides and bottom a bit.

Zone B - try making a large boarder with a hole in the middle - like a square donut, just inside Zone A. This way, you get the boarder crossing going into, then inside, then out.

Is this too bizarre? lol

Hi Nice idea will give it a go and see many thanks

MikeBwca wrote: ↑Mon Aug 02, 2021 6:06 pm According tot he BI manual, if you have only 1 zone... it's 'A' by default (if I'm reading that correctly).

If your only using one zone, there is no need for the 'Object crosses' field to be filled. It will trigger by default according to the 'Motion Sensor' settings.

Does anyone know if there's any benefit of specifying 1 zone for 'Object crosses'?
https://www.worktime.com

Hey!
I have the same problem with the camera.
I am very bad at it, so I would like to get some advice.
My Cross Objects box doesn't fire by default. Although I set up the "Motion Sensor" long ago.
Please tell me what could be the problem?