Blue Iris

LS,

I can succesfully send commands via CUSTOM HTTP for pan/tilt/zoom. When I enter the command for preset position 1 under "brightness 1", 2 under "brightness 2" etc. I can succesfully change to preset positions.
When I enter the same commands under PTZ Preset 1, 2 etc. Then go to "Edit presets" I am not able to call the preset positions.

How can I succesfully connect the CUSTOM HTTP commands to the "Edit presets"?

I have tried for Name/value: "PTZ Preset 1". Is there a specific name/value I need to enter to reach the custom http commands?

Thank you in advance.

This is my setting in * CUSTOM HTTP * for PTZ Preset 1.


This is my setting in * CUSTOM HTTP * for Brightness 0. When clicking PTZ Control - Brighness 0, the camera moves to the preset position. Validating this command.


These commands work as well (tested with the Brightness 0):
/web/cgi-bin/hi3510/preset.cgi?-act=goto&-number=1
http://192.168.1.200/web/cgi-bin/hi3510 ... &-number=1
http://user:pwd@192.168.1.200/web/cgi-b ... &-number=1

With "Preset positions" / "Edit presets..." after clicking "call", the camera won't move.


I believe there is a specific Name/value that I need to enter.

Ideas / suggestions are more than welcome!