Page 1 of 1
New to Blue Iris - Motion Detection Worked - Not Working Now - Help
Posted: Sat Dec 05, 2020 3:54 pm
by rgj34169
Can Someone Please Help. I just built a Server, Installed my Hikvision Camera's they worked, I setup Motion Detection it worked tried to get better cpu usage. Now no Motion Detection Capture.
Please Help.
Thanks
Joe
Re: New to Blue Iris - Motion Detection Worked - Not Working Now - Help
Posted: Sun Dec 06, 2020 8:58 pm
by atreyu
Woefully limited in information. Off the cuff thoughts, delete and recreate the camera if all else fails. Before that you can try verifying this: You need both the trigger and the action to record when triggered.
Re: New to Blue Iris - Motion Detection Worked - Not Working Now - Help
Posted: Mon Dec 07, 2020 7:42 am
by MikeBwca
Some screen captures needed...
- Blur Iris Status/Cameras
- Camera Settings/Record
- Camera Settings/Trigger
- Camera Settings/Trigger/Motion Sensor/Configure
A note about making changes to a camera... Always 'Export' the camera settings when the camera is working the way you want. This way, when you make additional changes, and the camera stops working, you can always 'Import' the settings back to get get the camera working again.
Same can be done in the Blue Iris settings.