Break time not working??
Posted: Sat May 29, 2021 8:46 pm
I'm trying to set a MINIMUM clip length of 30 seconds after motion is detected.
For each camera I set a "break time" of 30 seconds on the Trigger tab of its settings.
No luck - it regularly cuts off far earlier than 30 seconds.
Any hints as to why would be greatly appreciated.
See attached screenshots.
Version info: 5.4.6.4
Any leads would be greatly appreciated!
Jerry
For each camera I set a "break time" of 30 seconds on the Trigger tab of its settings.
No luck - it regularly cuts off far earlier than 30 seconds.
Any hints as to why would be greatly appreciated.
See attached screenshots.
Version info: 5.4.6.4
Any leads would be greatly appreciated!
Jerry