Blue Iris

Posted: **Fri Jun 04, 2021 8:33 am**

Hello,
we currently face an issue that one of our PTZ cameras(FI9928p) occasionally defaults to the home position on what we currently suspect to be a either related to a power loss or any other similar situation.

Is it possible check/change which preset/position the camera currently uses once connection is re-established?

Posted: **Fri Jun 04, 2021 6:05 pm**

Two ways to do this....

- Via the cameras gui. There is a 'home' position in the PTZ settings of the Foscam camera that will be set on camera power/restart.

- Via BI Cameras settings Watchdog tab. Signal restoration.

Blue Iris

Automatically change PTZ Position when on home?

Automatically change PTZ Position when on home?

Re: Automatically change PTZ Position when on home?