Status / Cameras reset gone missing?

[markn62]

Am I just having a brain glitch or did a recent upgrade do away with reset function in this window? Can't zero out the last three columns. Also the window is much larger and lost the scroll bar. Have to scroll right with the mouse wheel.

[BruceH]

I am running 5.9.9.25 and my Status /Cameras window has the reset button

Screenshot 2025-02-14 193552.png (84.48 KiB) Viewed 8941 times

[markn62]

I'm on the same version 5.9.9.25 and looks like this. Can't resize vertically either. Updated from the last version to this version and didn't change anything. Do I have to uninstall/reinstall?

[markn62]

Reinstalled 5.9.9.21 and now it's working normally again. Both 5.9.9.24 and 5.9.9.25 has "status window revisions" and "new status / overview page" in the release notes respectively. These are the two versions that screwed up my status window. Guess I'll stay put here until something newer comes out.

[BruceH]

I am guessing that you somehow managed to resize the window so that it is larger than your screen! I am pretty sure that there is a way to get it back using some keyboard commands, if I think of them I will post!

[BruceH]

What happens if you double click the top bar of the status window?

do you have the task bar set to autohide, if not then set it to autohide, it will probably reveal the bottom part of the window and you can drag it back up to shrink the window

[ManuelN]

I just ran into this issue. I'm running my server with a very old LCD screen that has a maximum resolution of 1366x768. I found that the reason why the buttons are missing is because of the low resolution. I attached another monitor to test this and once I was able to set the resolution higher, then the buttons reappeared. At 1280x800, the buttons do appear but still get placed behind the bottom of the window edge slightly (see screenshot).

Unfortunately, the only way I can see to "fix" this on our end is to increase the resolution of our display. If you have the monitor Scale above 100% then you can try lowering that as well.

I normally access my computer through Remote Desktop so what I've done is install this Virtual Display Driver and just set it as my primary monitor at a higher resolution.